Parker 650 Series - Electrical Installation and Wiring

Page 9
This guide has been produced by The Inverter Drive Supermarket Ltd.
All content, including but not limited to graphics, text and procedures copyright The Inverter
Drive Supermarket and must not be reproduced or altered without prior written permission.
©
Easy Start Guide
Parker SSD Drives 650 Series Inverter
7.5 Use the Menu, up and down keys to change the
value.
Press the Menu key to select the first digit. The selected
digit will flash to indicate that it can be changed.
Use the up and down keys to increase or decrease the
value.
Press the Menu key again to move through each digit
from right to left. Continue to press Menu to cycle back to
the first digit.
7.6 Press the “E” (Escape) key to return to the
Parameter List.
Press the Escape key to return to the parameter list. The
previously selected parameter number is shown.
Use the up and down arrows to select a different
parameter and press the Menu key to modify as before.
Press the Escape key again to return to the Parameter
menu as shown in 7.3.
7.7 Press the Escape key to return to the speed
reference screen.
When the display shows “par”, press the Escape key to
return to the initial screen.
7.8 The initial screen
The drive is now back at the speed reference screen.