Why is there a constant bleed from control solenoid top exhaust port on Parker Dehumidifier?
A constant bleed from the control solenoid top exhaust port on your Parker Dehumidifier indicates that the associated inlet or exhaust valve is defective (rebuild or replace) or the control solenoid is dirty or defective (clean or replace).
General| Brand | Parker |
|---|---|
| Model | Airtek TW 130 |
| Category | Dehumidifier |
| Language | English |
Inspect dryer upon arrival for damage, note on bill, and file claims with carrier.
Ensure piping/electrical integrity, proper pre-filtration, and correct ambient conditions.
Use caution, relieve pressure, disconnect power, wear protection, and handle desiccant safely.
Steps for powering, pressurizing, and energizing the dryer for operation.
Steps to safely isolate and depressurize the dryer before servicing.
Daily, weekly, semi-annual, and annual checks for optimal dryer performance.
Identifies common issues like dryer not operating, failure to switch, and outlet dewpoint problems.
To Next Page