Why is there a constant bleed from control solenoid top exhaust port on Parker Dehumidifier?
A constant bleed from the control solenoid top exhaust port on your Parker Dehumidifier indicates that the associated inlet or exhaust valve is defective (rebuild or replace) or the control solenoid is dirty or defective (clean or replace).
General| Brand | Parker |
|---|---|
| Model | Airtek TW 400 |
| Category | Dehumidifier |
| Language | English |
Ensure piping and electrical connections are intact; correct installation is vital for warranty.
Details minimum and ideal installation requirements including piping, filters, and drains.
Use caution, relieve pressure, disconnect power before servicing, and handle desiccant with care.
Warning about operating without mufflers; requires PPE due to noise and dust.
Reminder to always relieve pressure before servicing dryer or filters.
Steps for safely isolating the dryer, including repressurization and power removal.
Procedures for depressurizing the dryer, including valve operations and power disconnection.
Introduction to demand cycles (Cycle Loc, Pro Purge, Powerloc) for improved efficiency.
Details on the Cycle Loc feature for interfacing the dryer with an air compressor.
Safety caution regarding desiccant dust and necessary precautions.
Steps to safely shut down the dryer before performing valve repairs.
Troubleshooting steps for a dryer that fails to power on or show lights.
Troubleshooting steps for a dryer with power but not cycling or switching.
Diagnosing and resolving issues when the dryer fails to switch between cycles.
Identifying causes and solutions for high outlet dew point in the dried air.
Troubleshooting moisture detected downstream of the dryer.
Diagnosing and fixing excessive air loss during the tower regeneration phase.
Diagnosing and resolving leaks in exhaust valves during drying or repressurization.
Identifying causes and solutions for an excessive pressure drop across the dryer system.
Troubleshooting why the dryer unit may not fully repressurize its towers.
Identifying and resolving back pressure issues within the regenerating tower.
Troubleshooting inlet or exhaust valves that are not functioning correctly.
Diagnosing problems with the control air supply to the inlet and exhaust valves.
Troubleshooting constant bleed from control solenoid exhaust ports.
Troubleshooting constant bleed from the vent on the inlet.
Step-by-step guide for the initial setup of dryers equipped with the Powerloc system.
Instructions for correctly mounting the Powerloc sensor probe, including orientation and fittings.
Troubleshooting common issues with the Powerloc system, such as blank display or probe faults.
Steps for initiating a warranty claim and providing essential information to the factory.
To Next Page