4
DME012-RX - DME080-RX
Important: Do not operate this equipment until the safety information and instructions in this user guide have been read and understood by all
personnel concerned.
Only competent personnel trained, qualified, and approved by domnick hunter should perform commissioning, service and repair
procedures.
Use of the equipment in a manner not specified within this user guide may impair safety and invalidate your warranty.
When handling, installing or operating this equipment, personnel must employ safe engineering practices and observe all related
regulations, health & safety procedures, and legal requirements for safety.
Ensure that the equipment is depressurised and electrically isolated, prior to carrying out any of the scheduled maintenance instructions specified
within this user guide.
Most accidents that occur during the operation and maintenance of machinery are the result of failure to observe basic safety rules and proce-
dures. Accidents can be avoided by recognising that any machinery is potentially hazardous.
domnick hunter can not anticipate every possible circumstance which may represent a potential hazard. The warnings in this manual cover the
most known potential hazards, but by definition can not be all-inclusive. If the user employs an operating procedure, item of equipment or a method
of working which is not specifically recommended by domnick hunter the user must ensure that the equipment will not be damaged or become
hazardous to persons or property.
Should you require an extended warranty, tailored service contracts or training on this equipment, or any other equipment within the
domnick hunter range, please contact your local domnick hunter office.
Details of your nearest domnick hunter sales office can be found at: www.domnickhunter.com
1. Safety Information
To Next Page
Loading...
Need help?
General
