7
DME012-RX - DME080-RX
Electrical
Parameter Units DME012-RX - DME040-RX DME050-RX - DME080-RX
Supply Voltage V ac 110V ac 50/60Hz ± 10%
Power W 52 30
Fuse mA
500 (230v Supply)
1000 (110v Supply)
5 x 20mm time delay “T”
Environmental
Parameter Units DME012-RX - DME080-RX
Temperature
oC
(oF)
2 – 45
35 - 113
Humidity -
50% @ 40ºC
(80% MAX ≤ 31ºC)
IP Rating - IP65 / >NEMA 13
Pollution Degree - 2
Installation Category - II
Altitude
m
(ft)
< 2000
(6562)
Noise dB(A) <75dBA
Before continuing with the installation and commissioning of this equipment:
Ensure that it is correctly sized for the inlet pressure, taking into consideration the pressure drop caused by the valves, pipes and
filters within the system. Allowance should be made for purge air loss. The dryer should be typically sized at 1 bar (14 psi) 0.1MPa
below nominal compressor output pressure.
The purge air flow is factory set for 6 bar g (87 psi g) minimum system pressure. Should the minimum supply pressure be lower
than this figure the purge air flow must be reset in order to maintain the specified dewpoint.
Ensure that it is correctly sized for inlet temperature to meet the dewpoint specified.
Ensure that the electrical supply voltage and frequency meet the requirements detailed within this specification and on the
equipment rating plate.
Caution
2.1 Technical Specification
This specification is valid when the equipment is located, installed, operated, and maintained as specified within this user guide.
Specific
Parameter Units DME012-RX - DME040-RX DME050-RX - DME080-RX
Minimum Inlet Pressure
bar g
(psi g / MPa g)
4
(58 / 0.4)
Maximum Inlet Pressure
bar g
(psi g / MPa g)
16
(232 / 1.6)
13
(188 / 1.3)
Inlet Temperature
ºC
(ºF)
5 – 50
41 - 122
Inlet Connection NPT Inches 3/4” 1”
Outlet Connection NPT Inches 3/4” 1”
To Next Page
Loading...
