Parker H Series - Page 38

 •ChooseNext to set RPI.
 •ChooseFinish. Notice that the 1738-AENT is now under the
I/O configuration
H Series Fieldbus EtherNet/IP Adapter, Series A (PSSCENA) E104P
5
Wire the EtherNet/IP Adapter
Following are wiring instructions for the EtherNet/IP Adapter.
Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP67
requirements.
!
ATTENTION
Female In Connector
PSSCENANetworkConnector(D-CodedM12)
(view into connector)
Pin 1 - Tx +
Pin 2 - Rx +
Pin 3 - Tx -
Pin 4 - Rx -
Male In Connector
PSSCENAAuxiliaryPower(Mini7/8")
(view into connector)
Pin 1 - User Power +
Pin 2 - Adapter Power +
Pin 3 - Adapter Power -
Pin 4 - User Power -
NOTE: User power is the 24VDC power for field devices.
Adapter power is the 24VDC power for adapter. It is converted to
5VDC to power H Series Fieldbus modules.