Parker H2PEMPD-1300 - Unpacking; Overview of the Equipment; Locating the Equipment

Bulletin TI-H2PEMPD-D Installation, Operation and Maintenance Manual
Hydrogen Gas Generator H2 PEMPD series
6
1-800-343-4048 www.parker.com/balston
2.3.2 Unpacking
Once ready to install, remove the equipment from the packaging and check for signs of damage. Verify that the following items have
been included with the shipment:
Table 4
If any items are missing or damaged please contact your local Parker Hannifin office. Do not attempt to power up the generator.
2.3.3 Overview of the equipment
Figure 2
1 Control pa nel 8 Overflow drain
2 Options boa rd connection port 9 Fused IEC 320 inlet s ocket and ON/OFF s wi tch
3
O
2
vent (<250ml/min) 10 Wa ter bottle spillage drain
4
Exces s H
2
vent (<1 ml /mi n) 11 Environmenta l fi l ter
5 Wa ter bottle vent 12
Hydroge n outlet port val ve
6 Wa ter drai n 13 Purifi er
7 Auto water fi l l conne ction (fa ctory or fi eld fit opti on) 14 Wa ter level
15 H2 bleed outl et
Table 5
2.4 Locating the Equipment
This equipment is not suitable for use in any Hazardous, Flammable, or Explosive environments. Keep the
generator away from excessive heat and open flames.
Description Qty
Wa ter drain tube 1
Wa ter fil l tube
1
1
Dei oni zer ca rtridge 1
Environmental fil ters 2
Electrical s uppl y cable 5
1. Supplied only with generators fitted with the water fill option