Parker H2PEMPD-1300 - 5 Servicing; 5.1.1 Service Intervals

Bulletin TI-H2PEMPD-D Installation, Operation and Maintenance Manual
Hydrogen Gas Generator H2 PEMPD series
18
1-800-343-4048 www.parker.com/balston
5 Servicing
The recommended service procedures identified below, along with all other repair and calibration work should be undertaken by a
Parker Hannifin approved engineer.
5.1 Cleaning
Clean the equipment with a damp cloth only and avoid excessive moisture around any electrical sockets. If required you may use a
mild detergent, however do not use abrasives or solvents as they may damage the warning labels on the equipment.
5.1.1 Service Intervals
Table 11
Component Daily
6 months (4000
Hrs.)
24 Months
(16000 Hrs.)
Generator
Generator
Generator
Generator
Generator
Generator
Generator
Generator
Service
6 months (4000
Hrs.)
12 Months
(8000 Hrs.)
18 Months
(12000 Hrs.)
24 Months
(16000 Hrs.)
30 Months
(20000 Hrs.)
36 Months
(24000 Hrs.)
42 Months
(28000 Hrs.)
48 Months
(32000 Hrs.)
54 Months
(36000 Hrs.)
60 Months
(40000 Hrs.)
66 Months
(44000 Hrs.)
72 Months
(48000 Hrs.)
A
B
Key:
Check
Essential Procedure
Check for leaks
Recommended Service A
6 Month Service
Recommended Service B
24 Month Service
Operation
Check the power ON
indicator is illuminated
Check the STATUS / FAULT
indicator on the control
panel
Check the water level
Check the water
conductivity
Check the water bottle
spillage drains