Bulletin TI-H2PEMPD-D Installation, Operation and Maintenance Manual
Hydrogen Gas Generator H2 PEMPD series
5
1-800-343-4048 www.parker.com/balston
2.2 Weight and Dimensions
The dimensions and weight of the equipment are specified below.
Figure 1
Table 3
2.2 Receiving and Inspecting the Equipment
On receipt of the equipment carefully inspect the packaging for damage. If the packaging is damaged inform the delivery company
immediately and contact your local Parker Hannifin office.
2.3.1 Storage
If the equipment is to be stored prior to installation, do not remove it from the packaging. Ensure that it is stored in an upright
position as indicated by the arrows on the packaging
Do not attempt to lift the generator by yourself. It is recommended that the generator be carried by a minimum of
two persons or transported on a pallet truck.
Note. The storage area should be secure and the environmental conditions should fall within those specified in the technical
specification. If the generator is stored in an area where the environmental conditions fall outside of those specified, it is essential
that it be moved to its final location (installation site) and left to stabilize prior to unpacking. Failure to do this could cause
condensing humidity and potential failure of the generator.
Units H2PEMPD-510 H2PEMPD-650 H2PEMPD-850 H2PEMPD-1100 H2PEMPD-1300
in (mm) 17.1 (435) 17.1 (435) 17.1 (435) 17.1 (435) 17.1 (435)
in (mm) 13.5 (342) 13.5 (342) 13.5 (342) 13.5 (342) 13.5 (342)
in (mm) 21 (533) 21 (533) 21 (533) 21 (533) 21 (533)
in (mm) 25.4 (645) 25.4 (645) 25.4 (645) 25.4 (645) 25.4 (645)
in (mm) 4.3 (108) 4.3 (108) 4.3 (108) 4.3 (108) 4.3 (108)
in (mm) 4.4 (11.5) 4.4 (11.5) 4.4 (11.5) 4.4 (11.5) 4.4 (11.5)
in (mm) 2.3 (59.5) 2.3 (59.5) 2.3 (59.5) 2.3 (59.5) 2.3 (59.5)
lb (kg) 51.4 (23.4) 51.4 (23.4) 51.4 (23.4) 51.4 (23.4) 51.4 (23.4)
lb (kg) 60.2 (27.4) 60.2 (27.4) 60.2 (27.4) 60.2 (27.4) 60.2 (27.4)
To Next Page
Loading...
