Parker LevelController SCLSD

ENGLISHENGLISH ENGLISH
Operating Manual
LevelController SCLSD
UNIT
111
Note
The statements made in this operating manual are inten-
ded for users with specialised knowledge. It is essential
that the user checks the statements about the chosen
product for suitability for the functions requested. Because
of the various tasks and working processes in any system,
the user must check and make sure that all the demands
regarding the function and safety of the system are satis-
fi ed by the features of the product
Subject to alteration.
&&&&
Switch status indication
I = switch output 1
II = Switch output 2
(also error output)
Display of level
in mm, inch, %;
display of parameters
Arrow key to look back in menu or
to set a higher parameter
Arrow key to look forward in menu
or to set a smaller parameter
value
Enter key to select a parameter
value or to confirm a parameter
value
Display of the unit
LED‘s
4-position
digital display with
variable decimal point
Arrow key up
Arrow key down
Enter / OK
UNIT

Parker LevelController SCLSD Specifications

General

Brand	Parker
Model	LevelController SCLSD
Category	Controller
Language	English

Summary

Important Notes and Disclaimers

Digital Display Parameters

Switch Output Settings

Configure parameters for switch outputs S1 and S2, including switching points and reverse points.

Options Programme Settings

Configure options like password, units, display modes, offset, and analogue output settings.

Error Display and Handling

Error Codes and Descriptions

Details on error codes (Err 1, Err 3) and precautionary hints for device errors.

Installation Procedures

Mechanical Installation

Steps for attaching the level switch, including rotational housing adjustment for display positioning.

Electrical Installation

Guidelines for qualified electricians, protection against electromagnetic influences and over-voltages.

General Instrument Description

Safety Notes and Product Choice

Device Operation Modes

Programming Mode Details

Details on activating, protecting with password, and programming the device parameters.

Reset Mode

Procedure for resetting all settable parameters to factory default values.

Switching Functions

Hysteresis Function

Stabilizes switch status for fluctuating levels by defining hysteresis between SP and rSP.

Window Function

Monitors a defined range, activating output when the level is between SP and rSP.

Error Function

Configures switch output 2 as an error output, normally closed, opens on specific errors.

Analogue Output