Parker PA Series - Closing the Powerstation

Chapter 4: Maintaining the PowerStation Performing Internal Maintenance
PA PowerStation User Guide 4-7
4 Lift the backshell off of the PowerStation to expose the board.
You are now ready to perform any internal maintenance necessary.
Closing the PowerStation
1 Replace the backshell on the PowerStation.
2 Remount the PowerStation in the enclosure, refer to Installing the PA
PowerStation on page 2-7.
3 Reconnect the following cables:
• Power Input cable
• Ground cable
• any communication cables
• any keyboard and mouse cables
4 Turn on the PowerStation.