Parker PQDXXA-Z10 - Safety, Installation, and Electrical Connections; Security Advice; Mounting and Installation

8
Digital Pump Control Module
Series PQDXXA-Z10
Installation and Setup Manual
Bulletin HY30-3255-INST/UK
Parker Hannifin Manufacturing Germany GmbH & Co. KG
Pump & Motor Division Europe
Chemnitz, Germany
2. Security advice
Please read and follow this installation and setup
manual before installation, setup, start up, service,
repair and storage! Failure to follow the instructions
herein can cause severe damage to the electronic
or to the connected system.
Symbols
This manual makes use of symbols, which have to
be followed according to their meaning:
Remarks with regard to warranty
Remarks with regard to possible damage
to the electronic module or to any
connected pump or part of the system
Helpful additional instructions
Name plates, markings
Information direct attached to the module like con-
necting diagrams and name plates are to be kept
in readable condition.
Work with electronics
Working in the area of installation and commission-
ing of the electronics should only be done by quali-
edpersonnel.Thismeanspersonswhich have,
because of education, experience and instruction,
sufcient knowledge on relevant directivesand
approved technical rules.
3. Important notes
Intended usage
This operation manual is valid for module electron-
ics PQDXXA-Z10 series. Any different or usage
beyond it is deemed to be as not intended. The
manufacturer is not liable for warranty claims
resulting from this.
General instructions
Wereservetherightfortechnicalmodicationsof
the described product. Illustrations and drawings
withinthismanualaresimpliedrepresentations.
Due to further development, improvement and
modicationoftheproducttheillustrationsmight
not match precisely with the described unit. The
technical specications and dimensions are not
binding. No claim may result out of it. Copyrights
are reserved.
Liability
The manufacturer does not assume liability for
damage due to the following failures:
• incorrectmounting/installation
• improperhandlingandoperation
• lackofmaintenance
• operationoutsidethespecications
Storage
In case of temporary storage the electronic must
be protected against contamination, atmospheric
exposure and mechanical damages.
4. Mounting / Installation
Scope of Supply
Please check at receiving the shipment for
damages due to shipping. Report damages
immediately to the carrier, the insurance
company and the supplier!
The programming cable (only for setup
needed) is not part of the module shipment
and has to be ordered separately. (please
refer to page 3)
Mounting
• compareelectronicmoduletype(seeordering
code on name plate) with the parts list respec-
tively the circuit diagram
• themodulemaybemountedinanyorientation
• formountinganassemblyrailaccordingtoEN
50022 is required
Mounting rail dimensions: