Parker SciLog LabTec - Page 57

57


- PRINT - PARIT
Y
5.4 Setup: Ethernet
Ethernet is currently non-functional and is reserved for future development.
5.5 Setup: Printer
DOWN
DOWN
- PRINT - TYPE

TYPE:

SEIKO - PRINT - BAUD RATE BAUD RATE: 9600
UP DOWN
SELECT
UP DOWN
SELECT
UP DOWN SELECT
UP DOWN SELECT
DOWN
- PRINT - DTOP BITS STOP BITS: 1 - PRINT - PRINT DELAY PRINT DELAY: 0
UP DOWN SELECT
UP DOWN SELECT
UP DOWN SELECT
UP DOWN SELECT
PRINTER: Allows the setting of RS-232 communication parameters needed for connection to a
Parker serial printer or to a PC for data collection. These settings control the output for both the
Printer and USB Ports.
PRINT TIME: Controls how fast the LabTec™ sends data points in Minutes: Seconds. Max is 30:00 min-
utes; Min is 00:05 seconds. Default = 00:30 seconds.
TYPE: Allows use of two styles of small serial printers, Seiko, a thermal unit, and Starr, a dot matrix.
For all other printers, and PC communication, Seiko setting is used and is the default.
STOP BITS: Select 1 or 2. Default = 1.
PARITY: Select Even, Odd or None. Default = None.
WORD LENGTH: Select 7 or 8 Bits. Default = 8 Bits.
BAUD RATE: Select 300, 600, 1200, 2400, 4800, 9600, or 38.4. Default = 9600
PRINT DELAY: Used to slow down the output for printers with small buffers. Select 0 – 5 seconds.
Default = 0 seconds.
- SETUP - PRINTER
UP DOWN SELECT

SELECT
- PRINT - PRINT TIME PRINT TIME: 00:10- PRINT - WORD LENGTH WORD LENGTH: 8 BITS
UP DOWN SELECT UP DOWN SELECT UP DOWN SELECT UP DOWN SELECT