S3C Cellular Gateway
Installation Guide
SD-458 / 52019
1. COMPONENTS
Ensure all components are available:
A. Gateway
B. Cell Antenna (Qty. 2)
C. Ethernet Cable
D. 120VAC Power Supply
2. PRODUCT LABEL INFORMATION
Note key information on the product label located on the
gateway.
Cell Carrier Nomenclature:
LAT = AT&T
LVW = Verizon
S3C GATEWAY (LAT) S/N: XXXXXXX
STORE: XXXX XXXXXXXXX
24/7 SUPPORT: 1-888-920-6284
PROPERTY OF: PARKER HANNIFIN
206 LANGE DRIVE
WASHINGTON, MO
Cell Carrier Gateway S/N
A B C D
3. PLACEMENT
Find a dry location outside of the refrigerated display case
near the beginning or end of the S3C Ethernet network.
By placing the gateway at the beginning or end of the net-
work, it will allow the gateway to be plugged into the open
Ethernet port of the S3C Case Control. Alternatively, if it
is challenging to reach the end of the network, a CAT-5
Ethernet splitter can be used to accommodate a connection
in the middle of the network.
4. POWER SUPPLY
Install power supply cable to the back of the gateway.
CAT-5
Ethernet
Splitter
To Next Page
