Parkside PHDB 4 B2 User Manual

PHDB 4 B2
GB
│
MT
│
31 ■
♦ Start the engine with the pull starter ; pull firmly on the handle to do
this. If the engine does not start, pull the starter again.
♦ After starting, push the choke
back in (in the right position).
NOTE
► The procedure described in this section is suitable for both a cold
start and a warm start.
Turning the engine off
♦ Run the appliance for a short while without load before you switch it
off so that the appliance can "aftercool".
♦ Move the On/Off switch
to the "OFF" position.
♦ Close the fuel tap
Starting the appliance
♦ Switch on the water supply.
♦ Start the engine with the trigger
open.
NOTE
►
You can remove the jet pipe
or the nozzle to make starting
easier.
♦ Run the engine for 1 minute to warm it up.
Setting operating pressure and flow rate
■ The pressure and flow rate are fixed on this appliance and cannot be
changed.
Changing the nozzle
DANGER!
► Before changing the nozzle, switch off the appliance and pull the
trigger
to depressurise the appliance.
♦ Remove the nozzle
.
♦ Fit the new nozzle
.
Use with a cleaning agent
WARNING!
► Switch off the appliance before making any adjustments or carrying
out maintenance work.
WARNING!
► Unsuitable cleaning agents can damage the appliance and the
object to be cleaned.
Use only recommended cleaning agents that are suitable for
high-pressure cleaners.
This appliance is suitable for operation with the cleaning agents
recommended by the manufacturer. The use of other cleaning agents
or chemicals can have a negative effect on the safety of the machine.
► The recommended cleaning agents are primarily those that are suit-
able for use with high-pressure cleaners. These are available in
DIY and car accessory stores.
♦ Hang the cleaning agent hose
in a container with cleaning agent.
♦ Replace the high-pressure nozzle with low-pressure nozzle (black).
– 0° nozzle – red:
Extremely strong, precise jet. Cleans only a small area.
Do not use for cleaning wood!
– 15° nozzle – yellow:
Strong 15° jet for intensive cleaning of small surfaces.
Use only on surfaces and materials that can withstand high pressures.
– 25° nozzle – green:
25° jet for intensive cleaning of larger surfaces.
– 40° nozzle – white:
40° jet for cleaning large surfaces.
– Chemicals nozzle – black:
Low-pressure nozzle for the application of cleaning agents.
Recommended cleaning methods
– Dissolving dirt:
Spray the cleaning agent sparingly and leave to work for 1–5 minutes
but do not let it dry.
– Removing dirt:
Rinse off the dissolved dirt using a high-pressure jet.
After using with a cleaning agent
♦ Leave the appliance engine running and pull the trigger
for at least
1 minute to rinse itself.

Parkside PHDB 4 B2 Specifications

General

Brand	Parkside
Model	PHDB 4 B2
Category	Pressure Washer
Language	English