Parkside PPWSFA 20-Li A2 - Description of Functions; Technical Data

GB
MT
33
28 Storage case
Fig.A
29 Notch
30 Release lever (Guard cover)
Description of functions
The very fast rotating attachment tool en-
ables clean grinding, cutting or brushing
of metal.
Special attachment tools are provided for
each individual application. Please refer
to the information from the manufacturer.
Please refer to the descriptions below for
information on how the operating ele-
ments work.
Technical data
Cordless Flat Head Angle Grinder
...........................PPWSFA 20-Li A2
Rated voltage U .............................20V ⎓
Protection type .....................................IPX0
No-load rotation speed n
0
..... 8500 min
−1
Mounting flange ......................Ø22.2mm
Thread .................................................M14
Thread length of the grinding spindle
...........................................................12 mm
Sound power level (L
WA
)
.....................................94.4 dB; K
WA
=3 dB
Sound pressure level (L
pA
)
...................................... 86.4 dB; K
pA
=3 dB
Vibration (a
h
)
–Handle ...............2.60 m/s²; K=1.5 m/s²
–Auxiliary handle 4.41 m/s²; K=1.5 m/s²
Battery .................................................Li-Ion
Temperature ................................... ≤50 °C
– Charging ..................................4–40 °C
– Operation ................................ 0–50 °C
– Storage .................................... 0–45°C
PARKSIDE Performance Smart battery
Smart PAPS 204 A1/Smart PAPS 208 A1
– Frequency ƒ ........2400 – 2483.5 MHz
– transmitted power ...................≤ 20 dBm
Roughing wheel
............A24QBF 125x6x22.23 mm
Disc rotational speed n
max
≤12200 min
−1
Disc speed v
0
..............................80 m/s²*
diameter ........................................ 125mm
Borehole ...................................Ø22.2mm
Thickness ............................................ 6mm
* The grinding disc must withstand a rota-
tional speed of 80 m/s.
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
WARNING! Grinding thin metal
sheet or other well vibrating structures
with a large surface area can result in
increased noise exposure and a much
(up to 15dB) higher overall noise emis-
sion than the specified noise emission val-
ues. Use heavy flexible damping mats or
similar to prevent sound radiation from