Parkside PPWSFA 20-Li A2 - Cleaning; Cleaning, Maintenance and Storage; Parkside App

GB
MT
49
The charge level indicator (11) in the
control panel goes out.
3. Wait until the power tool has stopped
before placing it down.
4. If you are leaving the device unat-
tended or if you have finished work-
ing: Remove the battery (22) from the
device.
PARKSIDE app
The PARKSIDE app lets you monitor the
device and control certain functions. The
functions may change with updates to the
app and firmware. For more information
on the PARKSIDE app, see the instructions
for the smart battery.
Requirements
To find the device in the PARKSIDE app,
the following requirements must be met:
• The PARKSIDE app is installed on your
smartphone and Bluetooth® is activ-
ated.
• The following battery is inside the
device: PARKSIDE Performance Smart
battery PAPS204 A1 or PAPS208 A1.
This battery is already connected to the
PARKSIDE app.
The device communicates with the app
via the battery.
Connecting the device to the
PARKSIDE app
1. Insert the smart battery (22).
2. Press the Unlock button (13).
The “Connected” display (10) flashes
three times. When the device is con-
nected, the “Connected” indicator
lights up continuously.
3. Open the PARKSIDE app.
4. Devices.
The device is displayed in the list.
If the device does not appear in the
list, add the device manually.
Monitoring and controlling the
device
1. Devices.
2. Select the device from the list.
The device overview page is dis-
played.
3. Select the desired setting on the
overview page.
Select help if you are unsure.
A dialogue box with a description for
the relevant setting is displayed.
Cleaning, maintenance
and storage
WARNING! Risk of injury due to un-
intentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the bat-
tery (22).
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Cleaning the dust protection grille
(Fig.E)
• Clean the dust protection grille (3) with
a brush.
• You can remove the dust protection
grille for thorough cleaning. To do this,