En
Note: This checklist is not a replacement for the content included in this manual. Although it can be used as a quick start guide, we
strongly suggest reading through this manual completely before proceeding.
First Flight Preparation
Activity PNP BNF
Remove and inspect contents
u u
Begin charging ight battery
u u
Assemble Extra 300
u u
Install receiver
u
Connect servos to receiver or Y-harness
u u
Install fully charged battery
u u
Bind the receiver to a transmitter, if applicable
u u
Perform the Control Direction Test with the transmitter
u u
Adjust ight controls and transmitter
u u
Adjust battery for center of gravity (CG) see page 9
u u
Perform a radio system Range Check
u u
Find a safe and open ying eld
u u
Plan ight for ying eld conditions
u u
Maintenance After Flying
Activity PNP BNF
Disconnect ight battery from ESC (Required for Safety)
u u
Turn o transmitter (Required for Safety)
u u
Remove ight battery from aircraft
u u
Recharge ight battery
u u
Clean aircraft (wipe o dirt, etc.)
u u
Repair or replace all damaged parts
u u
Carefully disassemble and store aircraft
u u
Store ight battery apart from aircraft and monitor the battery charge
u u
Make note of ight conditions and ight plan results, planning for future ights
u u
General Assembly and Maintenance Tips
5
To Next Page
Loading...
