V7.5.0.0 – published on February 03, 2023 4
Prerequisites
Refer to the enclosed Super Quick Start Guide (SQSG) if you require illustrated guidance to get the
prerequisites out of the way.
1. Wake up the batteries of your ANAFI Ai and Skycontroller 4. Charge the batteries using the enclosed
USB-C to USB-C cables. The batteries’ LEDs start to flash, indicating that they are awake. Let them
charge while you read. Parrot recommends you always run a full charge of the smart batteries of
your drone and controller before flying ANAFI Ai.
2. Scan the following QR code to download the latest version of FreeFlight 7 available on your iOS
device. ANAFI Ai requires FreeFlight 7 to fly. The app enables you to update your Parrot
Skycontroller 4 and ANAFI Ai with the latest software version when you power them on for the first
time.
The fully secure piloting software of ANAFI Ai, FreeFlight 7, guarantees the integrity of data exchanges for
the full ecosystem, and manages updates (piloting software, drone, remote control).
When the download and install of FreeFlight 7 is complete, press the Power button of the Parrot
Skycontroller 4 and hold it for approximately 3 seconds to power it on. The main LED turns light blue.
Press the Push label of the gimbal protection with your thumb and position a finger on each side of the
gimbal to lift the gimbal protection away.
Press the Power button of ANAFI Ai and hold it for approximately 3 seconds to power it on. The drone’s
fan starts to turn.
Warning: The battery is updated automatically to version 7.5 during its first boot. Do not unplug the
battery while LEDs are flashing.
Use the enclosed USB-C to Lightning cable to connect your device to the right-side USB-C port of the Parrot
Skycontroller 4, and install it as shown in the enclosed SQSG.
To Next Page
Loading...
