2. Installing the Parrot USB Dongle
If your PC is already Bluetooth compatible, the use of the
Parrot USB Dongle and the installation procedure below are
not necessary.
System requirements:
• Min. processor speed 200 MHz
• RAM: Min. 64 MB, recommended 128 MB
• Free USB port (USB 1.1 and 2.0 standards)
• Windows® 2000, XP or Vista
1. Insert the software installation CD in the CD-ROM drive
of the computer.
> If you are using Windows 2000 or Windows XP, the
installation process will start automatically.
> If you are using Windows Vista, click on Execute Setup.
exe.
> If the installation does not start automatically, double
click on the drive letter associated to your CD-ROM drive
and double click on Setup.exe.
2. Click on Install Parrot Audio Suite.
> The Bluetooth installation window is displayed.
3. Click OK if you wish to use the Parrot USB Dongle.
> The «InstallShield Wizard» software will then install the
various functions available with the Parrot USB Dongle.
4. Follow the instructions on the screen.
> During the installation process you may be asked to
connect the Parrot USB Dongle. If the dongle is not yet
plugged into the computer, you must connect it to a USB
1.1/2.0 - compatible port on your PC or laptop. Then click
on OK to continue. If you want to continue the installation
without connecting the Bluetooth peripheral, click on
Cancel.
5. You will then see a message conrming that the driver has
been installed.
> Click on Finish to end the installation process.
importaNt: the usb adapter is seNsitive to static
electricity. the highly seNsitive electrical adapter compoNeNts
caN be damaged by static. to protect the peripheral, always
touch the metal case of the computer before haNdliNg the
usb adapter. this eNsures that you discharge aNy static
electricity. you should avoid aNy coNtact with the metal
coNNector wheN haNdliNg the usb adapter. very dry weather
or simply walkiNg across the floor caN cause a static charge
to build up oN your body.
To Next Page
Loading...
Need help?
Speakers
Memory
