Parrot DS1120 User Manual

English
13
4. Connecting the Parrot DS1120 to a
Bluetooth audio player
1. Switch the speakers ON and wait for the LEDs to ash
in blue.
2. Press the Conguration button.
> The blue LEDs start ashing quickly.
> The system is ready: you can now connect
your Bluetooth device.
3. On your Bluetooth audio source device, search for peri
pherals and select « Parrot DS1120 ».
> Refer to your audio player user guide for more informa
tion.
4. You are prompted to enter a PIN code : enter « 0000 » on
your source device.
> The Parrot DS1120 is ready to receive music.
> Subsequent connections will be established from
your device without any need to re-enter the PIN code.
Note : holdiNg dowN the coNfiguratioN buttoN for 5
secoNds restores the factory settiNgs aNd re-performs aN
auto-coNfiguratioN.
5. Standalone mode
• The Parrot DS1120 works as two independent speakers
if the auto-conguration phase does not occur correctly.
In that case, only one speaker is active and the LEDs are
red.
• To return to normal mode, bring the speakers close together
(less than 10m) and they automatically switch back to
normal mode by restarting the auto-setup phase.
6. Using several Bluetooth audio players
• The Parrot DS1120 can be paired up to 10 audio players.
• Several audio players cannot stream music at the same
time. You must rst stop the player currently streaming to
use other audio players.

Parrot DS1120 Specifications

Speakers

output power	2 x 15 W (RMS)
frequency range	100Hz – 18 kHz
dimensions	153 x 144 x 131 mm
weight	2 x 950g

Memory

flash memory	4MB
ram	8MB

Power Supply

ac voltage	100-240V ~ 50/60Hz
dc voltage	12V
dc current	2A