2.6 Warm up engine
1. After starting the engine, place the gear shift lever in neutral. For approximately the first 3
minutes after starting, warm up the engine by operating at one fifth throttle or less. Otherwise,
will shorten engine life.
2. Check for steady flow of water from the cooling water pilot hole.
CAUTION:
If water is not flowing out of the hole at all times while the engine is running, stop the engine
and check whether the cooling water inlet on the lower case or the cooling water pilot hole is
blocked.
If the problem cannot be located and corrected, consult your PARSUN dealer.
2.7 Shifting
WARNING:
Before shifting, make sure there are no swimmers or obstacles in the water near you.
CAUTION:
To shift from forward to reverse or vice versa, first close the throttle so that the engine
idles (or runs at low speeds).
19
To Next Page
Loading...
