3.2 Cleaning and adjusting spark plug
You should periodically remove and inspect the spark plug because heat and deposits will cause
the spark plug to slowly break down and erode. If necessary, you should replace the spark plug with
another of the correct type.
Before fitting the spark plug, measure the electrode gap with a wire thickness gauge; adjust the
gap to specification if necessary.
When fitting the plug, always clean the gasket surface and use a new gasket. Wipe off any dirt
from the threads and screw in the spark plug to the correct torque.
3.3 Checking the fuel system
1. Check the fuel lines for leaks, crack, or malfunction. If a problem is found, your PARSUN dealer
or other qualified mechanic should repair it immediately.
WARNING:
Check for fuel leakage regularly.
If any fuel leakage is found, the fuel system must be repaired by a qualified mechanic.
34
8-0.9
To Next Page
Loading...
Need help?
General
