CAUTION:
Change the gear oil after the first 10 hours of operation, and every 100 hours or at 6-month
intervals thereafter. Otherwise the gear will wear quickly.
4. Remove the oil level plug to allow the oil to drain completely.
CAUTION:
Inspect the used oil after it has been drained. If the oil is milky, water is getting into thegear
case which can cause gear damage. Consult PARSUN dealer.
5. Use a flexible or pressurized filling device, inject the gear oil into the gear oil drain screw
hole.（320cm
3
）
6. When the oil begins to flow out of the oil level plug hole, insert and tighten the oil level plug
(If necessary, change the seal spacer).
7. Insert and tighten the gear oil drain screw (If necessary, change the seal spacer).
3.10 Cleaning fuel tank
WARNING:
Keep away from sparks, cigarettes, flames, or other sources of ignition when cleaning
thefuel tank.
Cleaning the fuel tank in a well-ventilated open air.
1. Empty the fuel tank into an approved container.
2. Pour a small amount of suitable solvent into the tank. Install the cap and shake the tank.
Drain the solvent completely.
41
To Next Page
Loading...
Need help?
General
