5. Press in and hold the main switch to operate the
remote choke system. The remote chock switch
automatically returns to its normal position when
ou release your hand. Therefore keep the switch
pressed in.
NOTE:
It is not necessary to use the choke when starting a warm engine.
If the choke is left the home position while the engine is running, the engine will run poorly or
stall.
6. Turn the main switch to “START” (start), and hold it for a maximum or 5 seconds.
7. Immediately after the engine starts, release the main switch and allow it to return to “ON”(on).
CAUTION:
Never turn the main switch to “START” (start) while the engine is running.
Do not keep the starter motor turning for more than 5 seconds. If the starter motor is turned
continuously for more than 5 seconds, the battery will be quickly discharged, thus making it
impossible to start the engine. The starter can also be damaged. If the engine will not start
after 5 seconds of cranking, return the main switch to “ON”(on), wait 10 seconds, then crank
the engine again.
21
To Next Page
Loading...
Need help?
General
