ASLD2200 - Instruction Manual
4.1 Up and Down Buttons
The ASLD 2200 has 2 sets of Up and Down buttons; one set is on the outside of the enclosure the other set is on the
main printed circuit board (protruding above the front panel). Both sets have the same function. These buttons are
normally used to aid cleaning of the sensor by bringing the sensor to the surface.
Up and Stop
This button will cause the sensor to rise to the 100% point at the higher speed.
Down and Reset
This button will cause the sensor to return to automatic measurement
103370IM Issue 10 Date 19/03/2018 Page 11 of 30
To Next Page
Loading...