Particle Measuring Systems LASAIR II 310 Operator's Manual


Page Page 9-4 9-4 LASAIR LASAIR II II Operator’s Operator’s ManualManual
Chapter 9: RecipesChapter 9: Recipes
This button saves the current statistics parameters to a recipe. ItThis button saves the current statistics parameters to a recipe. It
operates like the save sampling parameters. For convenience, a copyoperates like the save sampling parameters. For convenience, a copy
of this button is also on the statistics setup page.of this button is also on the statistics setup page.
This button deletes the currently highlighted recipe. A recipe cannot beThis button deletes the currently highlighted recipe. A recipe cannot be
erased if it is attached to one erased if it is attached to one or more locations. The location attachmentsor more locations. The location attachments
must be deleted first.must be deleted first.
This button erases all recipes. A warning/confirmation promptThis button erases all recipes. A warning/confirmation prompt
is displayed before the recipes are erased. If locations areis displayed before the recipes are erased. If locations are
attached to recipes, then either the attachments must be attached to recipes, then either the attachments must be deleted, or the locationsdeleted, or the locations
must be deleted before the recipes can be deleted.must be deleted before the recipes can be deleted.
This button prints the highlighted recipe.This button prints the highlighted recipe.
Recipe NamesRecipe Names
Recipe names may be up to 16 characters. The following characters are illegalRecipe names may be up to 16 characters. The following characters are illegal
in recipe names: \, /, *, ?, “, <, >, :, and |.in recipe names: \, /, *, ?, “, <, >, :, and |.
FigurFiguree 9-2, “Set9-2, “Setup Screen, Loup Screen, Locationcations Page,” on pages Page,” on page 9-6, show9-6, shows the locats the locationion
association page of the Recipe Setup Screen. This display is a table of all theassociation page of the Recipe Setup Screen. This display is a table of all the
locations and recipe associations. Each recipe can be associated with multiplelocations and recipe associations. Each recipe can be associated with multiple
locations.locations.
To select a recipe to run at a location:To select a recipe to run at a location:
11 Open the Recipe Screen-Location PageOpen the Recipe Screen-Location Page
22
Press the blue enter key, to enter edit mode.Press the blue enter key, to enter edit mode.
Figure 9-1: Recipe Setup Screen, Setup PageFigure 9-1: Recipe Setup Screen, Setup Page

Particle Measuring Systems LASAIR II 310 Specifications

General

Brand	Particle Measuring Systems
Model	LASAIR II 310
Category	Measuring Instruments
Language	English