LLAASSAAIIR R III I OOppeerraattoorr’’s s MMaannuuaall PPaagge e 55--11
Chapter 5Chapter 5
SetupSetup
Setup is defining the parameters that will be used when collecting sample data.Setup is defining the parameters that will be used when collecting sample data.
The LASAIR II uses Setup Screens for the The LASAIR II uses Setup Screens for the following functions:following functions:
•• Sampling Setup Screen:Sampling Setup Screen:Assign parameters that directly relate to samplingAssign parameters that directly relate to sampling
••
Alarm Setup Screen:Alarm Setup Screen:
Specify the particle count or anSpecify the particle count or analog data that willalog data that will
trigger an audible or visual alarm or bothtrigger an audible or visual alarm or both
••
Main Setup Screen:Main Setup Screen:Enter a date and time, as well as use the PasswordEnter a date and time, as well as use the Password
functionfunction
••
Analog Display Setup Screen:Analog Display Setup Screen:
Enable and name your analog devicesEnable and name your analog devices
connected to the LASAIR IIconnected to the LASAIR II
•• Communications Setup Screen:Communications Setup Screen:Set the communications protocol modeSet the communications protocol mode
and enter the addresses for connections to a and enter the addresses for connections to a computer or to facilitycomputer or to facility
monitoring softwaremonitoring software
•• 4–20 mA input and Output:4–20 mA input and Output:(in Appendix I)(in Appendix I)
••
Statistics Setup:Statistics Setup:(in Chapter 8)(in Chapter 8)
••
Recipes:Recipes:
(in Chapter 9)(in Chapter 9)
Each setup screen is Each setup screen is covered in its own covered in its own section below. Information will include:section below. Information will include:
••
How to open the setup screenHow to open the setup screen
•• Setup screen iconsSetup screen icons
••
Field usageField usage
NOTE:NOTE: If you have configured the LASAIR II to be accessed by means ofIf you have configured the LASAIR II to be accessed by means of
Ethernet or serial communications, Ethernet or serial communications, always leave the instrument’s display onalways leave the instrument’s display on
either the Main Display Screen or the Anaeither the Main Display Screen or the Analog Display Screen. Otherwise, thelog Display Screen. Otherwise, the
remote PC will be unable to acremote PC will be unable to access the LASAIR II.cess the LASAIR II.
Edit ModeEdit Mode
TTo make any modifications to the o make any modifications to the current settings in a setup screen, you current settings in a setup screen, you mustmust
enable the Editing Mode by enable the Editing Mode by pressing the Enter button.pressing the Enter button.
Editing mode icons will replace the screen navigation icons.Editing mode icons will replace the screen navigation icons.
To Next Page
Loading...
Need help?
General
