After all packages were installed from PAX store Integra TE was not starting up
automatically.
This issue is a result of an incorrect initialization of TE the first time it starts up.
If this happens to you, please follow the steps below:
1. Launch the Integra Terminal application manually by tapping on the screen
2. If the terminal prompts for a password and on the top of the screen it reads “Display
over other apps”, please insert the PAX password.
3. and confirm
4. You should now be shown a screen where it reads “Allow display over other apps”
with a toggle switch on the right. Please enable it and leave this screen
5. The application will then ask for permissions to access contacts, phone calls, take
pictures and access photos – allow them all (one by one, in sequence)
6. After these steps, the Integra TE application should be ready to be initialized as any
other PAX.
To Next Page
Loading...
