EasyManua.ls Logo

PAX E700 - Install SIM or Micro SD Card; SIM;SD Card Installation

PAX E700
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Date: 08-20-2019 13 PAX Customer Support
Version: 1.0 support@pax.us
(877) 859-0099
www.pax.us
E700 REFERENCE GUIDE
7 Paper Roll
One roll of thermal paper is included in the E700 terminal box.
7.1 Dimensions
The paper roll dimensions are:
Width3.14 inches (80 mm)
Diameter 3.14 inches (80 mm)
Length 108.3 feet (33 m)
PAX Technology recommends purchasing additional paper rolls from an office supply store.
7.2 Loading the Paper
1. When the printer is out of paper, the yellow Paper Out indicator lights up. To load paper,
press the gray button on the left side of the terminal to open the cover, as shown below:
2. Load the paper roll into the paper compartment and extend the end of the paper out of the
printer.
3. Close the printer cover. The Paper Outindicator light turns off.
7.3 Tear Paper
When connected to power, the E700 automatically cuts excess paper when the paper holder is closed. If
the E700 is running on battery power, you can tear the paper by hand.
1. Tilt the paper toward the bottom of the terminal at about a 45-degree angle.
2. Pull the paper from the left or right across the tear off bar inside the terminal.

Table of Contents

Related product manuals