PAX S920 - Frequently Asked Questions

S920 Reference Guide
v1.0 | 25
6.Enter the Wi-Fi [password].
7.Select [DHCP] if the IP changes or [Static] if the IP always stays the same.
Note:
• If the user selects [DHCP], the terminals acquires the IP address and displays the IP
information.
• If the user selects [Static], enter the IP address, netmask address, gateway address, and DNS
server address. The input format is XXX.XXX.XXX.XXX. The terminal displays the IP information.
8.[IP Config] screen displays with the applicable information.
9.Press the [X] button on the keypad multiple times to return to the [WiFi] screen.
10.From the [WiFi] screen select Auto Connect then select [Open].
11.Press the [X] button on the keypad until the device displays QUIT TM.
12.Select [Yes-Enter].
13.Terminal connects to Wi-Fi.
12. Frequently Asked Questions
Q: What should I do if my terminal does not start?
A: First check to see if the battery is still charged. Attempting to power on the device while the battery
is empty will cause a prompt to appear on screen, indicating that the battery power is too low. If
plugging the device into the power adapter does not cause a battery charging icon to appear on
screen, check the power adapter to see if it is operating normally. If the battery is charged but the
terminal still refuses to power on, contact an agent from your local vendor.
Q: Why is the battery not fully charging?
A: The rechargeable battery has systems in place to prevent wear and tear and to help preserve its
maximum capacity. In addition, operating the terminal while it is being charged will cause the battery
to rise in temperature, resulting in damage to the battery and a decline in its maximum capacity. It is
highly recommended that the device is put into sleep mode when not in immediate use and that it is
not used while the battery is charging.