NMS044 Reference Manual Configuring the Gateway for Larson Davis Instruments A-12
Step 2. Open a web browser, and enter http://192.168.14.31:9443 in the address field.
Step 3. Enter the factory default User Name and Password, and log in to ACEmanager.
TAKE NOTE The factory default user name and password are labeled on the
bottom of the RV50X gateway. To view this, remove the RV50Xgateway from the
base plate, as shown in Figure 2-5
Removing the Gateway From the Case Plate.
If no label is present on the bottom of the modem, the default password is
“12345”.
Step 4. Take note of the device’s firmware version. If needed, update to the latest
version.
Updating Firmware to the Latest Version (Recommended)
a.
In a browser, go to http://source.sierrawireless.com/.
b. Select the name of your device, then select Firmware Package.
c. If needed, download and update the firmware according to the manufacturer's
instructions.
Step 5. Log in again when the system is rebooted as shown in step 3–4.
Step 6. Change your password as shown in the following process.
Changing Your Password:
a.
Navigate to the Admin tab.
b. Enter the factory default User Name and Old Password.
Figure A-10 Admin Tab
c.
Enter a unique password in New Password, and again in Retype Password.
d. Record your password. If you forget it you will need to reset the RV50X to factory
settings and complete this process again.
e. Click Change Password, then click Apply.
Recommended Next Step:
Choose one of the following sections:
• A.5.2
Configuring LD Settings Utilizing the Template File
• A.5.3 Configuring LD Settings Without the Template File
To Next Page
Loading...