16
5• Make sure that the latch strap is
threaded flat against the base.
6• Tighten the base against the seat
by pulling the free end of the latch
strap. Press down on the base with
your body weight and tighten
further. Check the level indicator. If
the pointer has moved outside of the
green area, turn the knob until the
pointer is back within the green area.
You may need to loosen the strap
slightly to do this. Push and pull on
the base. If you can move it more
than 2,5 cm (1 inch), tighten the belt
further.
• Nowthatyouhaveinstalledthe
base, go to page 23.
To Next Page
Loading...
Need help?
General
