Pegatron IPMIP - BIOS Security Features

IPMIP Motherboard Reference Guide 35
8 BIOS Setup reference
BIOS Security Features
΄ΖΔΦΣΚΥΪ΄ΖΥΥΚΟΘΤ
ʹΙΒΟΘΖ΄ΦΡΖΣΧΚΤΠΣ΁ΒΤΤΨΠΣΕ
ͳͺ΀΄΄ΖΔΦΣΚΥΪͷΖΒΥΦΣΖΤ
͹ΖΝΡͺΥΖΞ
ͺΟΤΥΒΝΝΠΣΔΙΒΟΘΖΥΙΖ
ΡΒΤΤΨΠΣΕ
ʹ;΀΄΄ΖΥΦΡΆΥΚΝΚΥΪʹΠΡΪΣΚΘΙΥʹͲΞΖΣΚΔΒΟ;ΖΘΒΥΣΖΟΕΤͺΟΔ
΄ΦΡΖΣΧΚΤΠΣ΁ΒΤΤΨΠΣΕͿΠΥͺΟΤΥΒΝΝΖΕ
ΆΤΖΣ΁ΒΤΤΨΠΣΕ ͿΠΥͺΟΤΥΒΝΝΖΕ
Ό΁ΣΖΤΤͶΟΥΖΣΎ
˦˨˥
;ΠΧΖ
ͷͷΒΚΝ΄ΒΗΖ͵ΖΗΒΦΝΥΤ ͷ΀ΡΥΚΞΚΫΖΕ͵ΖΗΒΦΝΥΤ
·ΒΝΦΖͶΟΥΖΣ΄ΖΝΖΔΥͷ΄ΒΧΖͶ΄ʹͶΩΚΥͷ͸ΖΟΖΣΒΝ͹ΖΝΡ
˥
Enter New Password
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on the top of the screen shows the default Not Installed. After you
set a password, this item shows Installed.
To Set A Supervisor Password:
1. Select the Change Supervisor
Password item and press <Enter>.
2. From the password box, type a
password composed of at least six
letters and/or numbers, then press
<Enter>.
3. Conrm the password when
prompted.
The message “Password Installed” appears after you successfully set your
password. To change the supervisor password, follow the same steps as in setting
a user password. To clear the supervisor password, select the Change Supervisor
Password then press <Enter>. The message “Password Uninstalled” appears.
NOTE: If you forget your BIOS password, you can clear it by erasing the
CMOS Real Time Clock (RTC) RAM. See your hardware documentation for
information on how to erase the RTC RAM.