pellenc Excelion 2000 PROFESSIONAL - Page 37

37
Repaired by
User User
PELLENC
approved dealer
PELLENC
approved dealer
PELLENC
approved dealer
User
PELLENC
approved dealer
Solutions
Change the cutting blade
Change the crown
Change the metal blade
retaining element
Change the motor shaft
Change the blocking
device
Checks
Check the blade’s
condition (no cracks or
deformations)
Check there are no
deformations
Check there are no
deformations
Check the shaft’s condition
(no deformations)
Clean the cams
Check the condition of the
teeth
Probable cause
Damaged cutting blade
Damaged crown
Damaged cutting blade
retaining element
Damaged motor shaft
Fouled cutting head
Worn notched cam teeth
Condition of
diodes
On On
Condition of battery
start/stop switch
I I
Symptoms
The cutting head
(wire or metal blade)
makes an abnormal
noise or vibrates
heavily
Cutting wire ejected
during use
INCIDENTS