pellenc Excelion 2000 PROFESSIONAL - Page 38

38
INCIDENTS
Repaired by
PELLENC
approved dealer
PELLENC
approved dealer
User User
Solutions
Change the trigger or
sensor
Change the cord
Allow tool to cool for
approximately 5 minutes
Recharge the battery (if
less than 10%)
Checks
At PELLENC approved
dealer premises
Check the condition of the
cord
4 beeps on the battery
When stopped, check
the battery charge level
indicated on the side
display
Probable cause
A trigger no longer
functions
The power cord is
sectioned
The tool has reached its
temperature limit
The battery is discharged
Condition of
diodes
On
Off
Condition of battery
start/stop switch
I
Symptoms
The tool stops during
use