pellenc EXCELION 2000 - Machine Balancing; USAGE; Positioning and Powering Up the Tool

15
2
1
53_12_019B
53_14_002A
6200 rpm
53_14_007A
53_14_001A
4200 rpm
6200 rpm
53_14_003A
A1 A2
1 - Position the harness equipped with its battery.
2- Attach the machine to the harness and make sure it is balanced and well adjusted.
4- Connect the power cord to the machine
5. Power up the tool to select one of the following operating modes:
3- Check that the cutting tool does not touch the ground. Make sure the work area is clear and there is nobody within a
15 metre radius. Check your safety devices.
 INENIN
Put the harness hook on one of the 4 attachment positions
available on the tool.
Use the attachment point which gives you the best tool balance.
■ USAGE
■ PUTTING THE MACHINE INTO SERVICE
Mode 1
Mode 2