pellenc EXCELION 2000 - INCIDENTS; Tool Does Not Start Troubleshooting

38
■ INCIDENTS
Repairer
User
PELLENC
authorised
distributor
User
PELLENC
authorised
distributor
PELLENC
authorised
distributor
PELLENC
authorised
distributor

Flip the battery switch
Change the cable
Charge the battery
Change the electronic
board if the diodes remain
off after starting and
checking the previous
points
Change the trigger or
sensor
Change the circuit board

Battery switch
Check the condition of the
cable
Check that the battery is
not fully discharged
At an authorised
PELLENC distributor
At an authorised
PELLENC distributor
At an authorised
PELLENC distributor

Battery is off
The power cable is
severed
Battery
Electronic circuit boards
A trigger is no longer
operating
Electronic circuit boards

E
Off Off
On



0
I

The tool does not
start