pellenc EXCELION 2000 - Cutting Head Noise;Vibration Troubleshooting; Cutting Wire Ejection Troubleshooting

39
Repairer
User User
PELLENC
authorised
distributor
PELLENC
authorised
distributor
PELLENC
authorised
distributor
User
PELLENC
authorised
distributor

Change the cutting blade
Change the cover
Change the metal blade
holding part
Change the motor shaft
Change the blocking
device

Check the blade’s
condition (no cracks or
deformations)
Check there is no
deformation
Check there is no
deformation
Check the condition of the
shaft (no distortion)
Clean the cams
Check the condition of the
teeth

Damaged cutting blade
Damaged crown
Damaged cutting blade
holding part
Motor shaft damaged
Fouled cutting head
Worn notched cam teeth

E
On On



I I

The cutting head (wire or metal blade) makes
an abnormal noise or
vibrates heavily
Cutting wire ejected
during use
■ INCIDENTS