pellenc EXCELION 2000 - Tool Stops During Use Troubleshooting

40
■ INCIDENTS
Repairer
PELLENC
authorised
distributor
PELLENC
authorised
distributor
User User

Change the trigger or
sensor
Change the cable
Let the tool cool down
for roughly 5 minutes
Recharge the battery (if
less than 10% charged)

At an authorised
PELLENC distributor
Check the condition of the
cable
4 beeps from the battery
When stopped, check the
battery charge level shown
in the side window

A trigger is no longer
operating
The power cable is
severed
The tool has reached its
temperature limit
The battery is at

E
On
Off



I

The tool stops during
use