Pelpro PPC90 - Pellet Venting Requirements

PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 7
Installing Your Stove
Installing Your Stove
REQUIRED:
U se on ly 3” or 4 ” ty pe “ L ” or “ PL ” pellet pi pe.
CAUTION
• D o n ot con n ect to an y ai r d i stri b u ti on d u ct or sy stem
• Do not install a ue damper in the exhaust venting system of this
stove
• Do not connect this stove to a chimney ue serving another
appli an ce
• The structural integrity of the manufactured home oor, wall and
cei li n g /roof mu st b e mai n tai n ed
C
C
Installation Video
V i si t pelprostoves.com or scan th i s cod e:
Pro Tip
This unit can be installed with a 3 to 6 inch (76-152mm) Top Vent Offset Adapter Kit. The 3
to 6 inch (76-152mm) Top Vent Offset Adapter are tested to use 24 gauge single wall ue
connector or Listed double wall ue connector to Class A Listed metal chimneys, or masonry
chimneys meeting International Conference of Building Ofcials (ICBO) standards for solid
f u el appli an ces.
Getting Ready (Continued)
Pellet Venting
Adding bends in the exhaust path restricts air ow,
red u ces perf orman ce an d provi d es a collecti on poi n t
for ash deposits requiring more frequent cleaning.