Pelpro PPC90 - Trim Adjustment for Burn Control

PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 17
Using Your Stove
If your stove tries to start but fails on the initial burn, it will display MISSED IGNITION.
1. Turn your stove to off, remove and clean
the repot
2. Conrm repot is properly positioned
3. Ensure there are enough pellets in the hopper.
4. Prime your stove per previous instructions
PWR TO RESET
MISSED IGN
Using Your Stove
Trim Adjustment
Trim adjustment is located in the menu. This feature will
adjust the air/fuel ratio and below are examples of when to
use it:
WARNING!
This wood heater needs periodic inspecion and repair for proper operation. It is against federal regulations to
operate this wood heater in a manner inconsistent with operating instructions in this manual.
• If the re is too large, lazy or producing black soot, adjust trim down one level at a time and allow
15 minutes for stabilization before making another adjustment
• If your re is too small and sometimes goes out when there are pellets in the hopper, adjust
the trim up one level at a time and allow 15 minutes for stabilization before making another
adjustment.
Turning Your Stove Off
3
Auger stops feeding pellets.
Blowers continue to run until
after the exhaust temperature
has cooled.
1
CAUTION!
Smoke Hazard
• Press power button on display to OFF,
let appliance completely cool and
exhaust blower must be off. Now you
can unplug appliance before servicing
• Smoke spillage into room can occur if
appliance is not cool before unplugging
Press and hold power button
for 3 seconds
2
-2
TRIM