Pelpro PPC90 - Listings and Certifications; Mobile Home Approval; Appliance Certification

PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com28
Listing and Code Approvals
Mobile Home Approved
This appliance is approved for mobile home
installations when not installed in a sleeping room and when an outside combustion air inlet is
provided.
• The structural integrity of the mobile home oor, ceiling, and walls must be maintained
• The appliance must be properly grounded to the frame of the mobile home with #8 copper
ground wire, and use only listed double-wall connector pipe
• Outside Air Kit provided with each stove must be installed in a mobile home installation
and must remain clear of leaves, debris, ice and/or snow. It must be unrestricted while the
appliance is in use to prevent room air starvation which causes smoke spillage.
• The appliance must be secured to the mobile home structure by bolting it to the oor through
holes provided at bottom of your cast legs on your stove.
Listings and Certications
WARNING! Asphyxiation Risk.
DO NOT INSTALL IN A SLEEPING ROOM. Your stove consumes
oxygen in the room.
Note
This installation must conform with local codes.
In the absence of local codes you must comply with ASTM E1509-12, ULC S627-00, (UM) 84-HUD
WARNING!
• It is critical to have a working smoke detector installed in the home of unit operation.
• Smoke alarms that are properaly installed and maintained play a vital role in reducing re deaths and injuries. Having
a working smoke alarm reduces the chance of re related injuries.
• Install at least one carbon monoxide detector on each oor of your home.
Appliance Certication
Series PPC90/TSC90
Laboratory OMNI-Test Laboratories, Inc.
Report No. 0061PS093S
Type Solid Fuel Room Heater/Pellet Fuel Burning Type
Standard ASTM E1509-12 and ULC S627-00, Room Heater
Pellet Fuel Burning type and (UM) 84-HUD, Mobile
Home Approved.
O-T L
Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C
US