Pelpro PPC90 - Glass Specification; Stove Dimensions

PelPro Cast Pellet Stove • 7093-600 • 07/13/16pelprostoves.com 29
Listing and Code Approvals
Glass Specications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact PelPro for replacement glass.
Electrical Rating (On High)
PPC90/TSC90 Series: 115 VAC, 60 Hz, Start 2.6 Amps,
Run 0.9 Amps
Listings and Certications
Model PPC90/TSC90
Laboratory OMNI-Test Laboratories, Inc.
Report No. 0061PS093E
EPA Certied 1.11 grams/hr
*BTU Input 11,055 - 47,378 / hr
*BTU Output 8,456 - 39,482 / hr
Efciency HHV 82.3%
**Heating Capacity
Up to 2,200 sq. ft.
depending on climate zone
Vent Size 3” or 4” L or PL
Hopper Capacity 90 lbs (Approximate)
Fuel Wood pellets
Shipping Weight 340 lbs
Standard
EPA Certication 2015, test method: ASTM
E2779-10
O-T L
Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C
US
*BTU input/output will vary, depending on the brand of fuel you use in your stove.**Heating capacity depends on
climate zone, structure layout, insulation, windows, etc.
Stove Dimensions
This manual describes the installation
and operation of the Brand PelPro,
Model PPC90/TSC90 wood heater.
This heater meets the 2015 U.S.
Environmental Protection Agency’s
crib wood emission limits for wood
heaters sold after May 15, 2015.
Under specic test conditions this
heater has been shown to deliver heat
at rates ranging from 11,055 to 47,378
Btu/hr.
BTU & Efciency Specications
9-3/8 [238]9-3/8 [238] 4 [102]
26-3/4 [679]
28 [711]
32-1/8
[816]
25-1/4 [642]
9-5/8
[246]
FLUE
15-3/4 [400]