PelPro Cast Pellet Stove • 7093-600 • 07/13/16 pelprostoves.com20
Maintaining Your Stove
Zone 2 - Stove Body
Convection Blower
• Remove right side panel to access and
remove convection blower
• Vacuum any debris from the fan blades and
blower housing
Hopper
• Empty hopper of any pellets
• Vacuum any remaining pellets/debris from the
hopper
MONTHLY
AS NEEDED
OR
WARNING!
Glass is 5mm thick high temperature heat resistant ceramic glass.
• DO NOT REPLACE with any other material
• Alternate material may shatter and cause injury
CAUTION!
Handle glass assembly with care and refer to maintenance instructions. When cleaning glass:
• Avoid striking, scratching or slamming glass.
• Do NOT clean glass when hot
• Do NOT use abrasive cleaners
• Do NOT operate with glass cracked, broken or scratched
Maintaining Your Stove
Pro Tip
The type of fuel you are burning will dictate how often you have to clean your repot.
If the fuel you are burning has a high dirt or ash content, it may be necessary to clean the
repot more than once a day.
Poor quality fuel will cause clinkers to form in the repot. Clinkers are formed when dirt, ash
or a non-burnable substance is heated to 2000 deg. F (1093 deg. C) and becomes glass-
like.
Always burn dry fuel. Burning fuel with high moisture content take heat from the fuel and
tends to cool the appliance, robbing heat from your home.
Damp pellet fuel can clog the feed system.
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone
To Next Page
Loading...
