EasyManua.ls Logo

Pentair FLECK 5800 SXT - Diagnostic Programming Mode Sxt

Pentair FLECK 5800 SXT
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 - DIAGNOSTIC PROGRAMMING
MODE SXT
Abbreviation Parameter Description
FR Flow Rate Displays the current outlet
ow rate.
PF Peak Flow Rate Displays the highest ow
rate measured since last
regeneration.
HR Hours in Service Displays the total hours
that the unit has been in
service.
VU Volume Used Displays the total volume
of water treated by the
unit.
RC Reserve Capacity Displays the system's
reserve capacity calculated
from the system capacity,
feedwater hardness, and
safety factor
SV Software Version Displays the software
version installed on the
controller.
NOTE: Some items may not be shown depending on timer
conguration. The timer will discard any changes
and exit User Programming Mode if a button is not
pressed for 60 seconds.
Diagnostic Programming Mode Steps
1. Press the Up and Down buttons for ve seconds while in
service.
2. Use this display to view the current Flow Rate. This option
setting is identied by "FR" in the upper left hand corner of
the screen.
Figure 34
3. Press the Up button. Use this display to view the Peak Flow
Rate since the last regeneration cycle. This option setting
is identied by "PF" in the upper left hand corner of the
screen.
Figure 35
4. Press the Up button. Use this display to view the Hours
in Service since the last regeneration cycle. This option
setting is identied by "HR" in the upper left hand corner of
the screen.
Figure 36
5. Press the Up button. Use this display to view the Volume
Used since the last regeneration cycle. This option setting
is identied by "VU" in the upper left-hand corner of the
screen.
Figure 37
6. Press the Up button. Use this display to view the Reserve
Capacity. This option setting is identied by "RC" in the
upper left hand corner of the screen.
Figure 38
7. Press the Up button. Use this display to view the Software
Version. This option setting is identied by "SV" in the
upper left hand corner of the screen.
Figure 39
8. Press the Extra Cycle button to end Diagnostic
Programming Mode.
Fleck 5800 LXT & SXT Downow/Upow MR12 • 17

Other manuals for Pentair FLECK 5800 SXT

Related product manuals