Pentair FLECK SXT - Table of Contents; Job Specification Sheet; California Proposition 65 Warning

TABLE OF CONTENTS
TABLE OF CONTENTS ..........................................................2
JOB SPECIFICATION SHEET ................................................2
California Proposition 65 Warning .......................................2
TIMER FEATURES ................................................................3
TIMER OPERATION ..............................................................4
MASTER PROGRAMMING MODE CHART ............................5
MASTER PROGRAMMING MODE .........................................6
MASTER PROGRAMMING MODE continued ........................................ 7
MASTER PROGRAMMING MODE continued ........................................ 8
USER PROGRAMMING MODE .............................................. 9
DIAGNOSTIC PROGRAMMING MODE ................................10
2510/2750/2850S TIMER ASSEMBLY ................................. 11
9000/9100/9500 TWIN TANK TIMER ASSEMBLY ...............12
3/4-INCH PLASTIC TURBINE METER ASSEMBLY .............13
PLASTIC PADDLE METER ASSEMBLY ...............................14
3/4-INCH BRASS PADDLE METER ASSEMBLY .................15
1-INCH BRASS PADDLE METER ASSEMBLY ....................16
1-INCH STAINLESS STEEL METER ASSEMBLY ................ 17
INLINE PLASTIC TURBINE METER ASSEMBLY ................18
1-1/2 INCH BRASS METER ASSEMBLY ............................ 19
1-1/2 INCH STAINLESS STEEL METER ASSEMBLY .......... 20
3/4-INCH, 1-INCH or 1-1/2 INCH PADDLE WHEEL METER
CAP ASSEMBLY ..................................................................21
TROUBLESHOOTING .......................................................... 22
2510SXT WIRING DIAGRAM ............................................... 23
2750SXT/2850SXT WIRING DIAGRAM ................................24
9000SXT/9100SXT/9500SXT WIRING DIAGRAM ................25
SERVICE ASSEMBLIES ......................................................26
JOB SPECIFICATION SHEET
Job Number: ______________________________________________
Model Number: ____________________________________________
Water Hardness: __________________________________ ppm or gpg
Capacity Per Unit: __________________________________________
Mineral Tank Size: ___________ Diameter: ________Height: ________
Salt Setting per Regeneration: ________________________________
1. Type of Timer:
A. 7 Day or 12 Day
B. Meter Initiated
2. Downflow: Upflow Upflow Variable
3. Meter Size:
A. 3/4-inch Turbine
B. 3/4-inch Paddlewheel
C. 1-inch Turbine
D. 1-inch Paddlewheel
E. 1-1/2 inch Turbine
F. 1-1/2 inch Paddlewheel
G. Generic ______Pulse Count _______ Model ____________
4. System Type:
A. System #4: 1 Tank, 1 Meter, Immediate, or
Delayed Regeneration
B. System #4: Time Clock
C. System #4: Twin Tank
5. Timer Program Settings:
A. Backwash: ______________________________ Minutes
B. Brine and Slow Rinse:_____________________ Minutes
C. Rapid Rinse: ____________________________ Minutes
D. Brine Tank Refill: ________________________ Minutes
E. Pause Time: ____________________________ Minutes
F. Second Backwash: _______________________ Minutes
6. Drain Line Flow Control: gpm
7. Brine Line Flow Controller: gpm
8. Injector Size#:
9. Piston Type:
A. Hard Water Bypass
B. No Hard Water Bypass
CALIFORNIA PROPOSITION 65 WARNING
WARNING:
This product contains chemicals known to
the State of California to cause cancer or
birth defects or other reproductive harm.
2 • FLECK SXT Timer Service Manual