18
IntelliFlo VS+ SVRS Installation and User’s Guide
Quick Clean (Continued)
To access the Quick Clean menu:
1. Check that the green power LED is on.
2. Press the Menu button. “Settings” is displayed.
3. Use the Down arrow button to scroll to “Features”.
5. Press the Select button. “Timeout” is displayed.
6. Press the Down arrow button. “QuickClean” is displayed.
7. Press the Select button. “Set Speed” is displayed.
8. Press the Select button. The “RPM” first (ones) column will highlight.
9. Use the Up or Down arrow button to change the speed.
10. Press the Enter button to save the setting.
11. Press the Down arrow button. “Time Duration” is displayed.
12. Press the Select button. The cursor will appear in the minutes column.
13. Use the Up or Down arrow button to change the time from 1 minute to 10 hours.
14. Press the Enter button to save the setting. Note: To cancel any changes, press the Escape button to
exit without saving.
15. Press the Escape button to exit.
Features: Time Out
This feature keeps the pump from running for a programmable amount of time. This feature can be used to
allow newly glued pipe joints time to dry before circulation of the pool water is resumed. This feature keeps
the pump from running for a programmable amount of time. When this feature's time is up the pump will be
in the “Running Schedule” mode, Start/Stop LED will be lit and ready to turn on at the next scheduled run
time.
To access the Time Out menu:
1. Check that the green power LED is on.
2. Press the Menu button. “Settings” is displayed.
3. Use the Down arrow button to scroll to “Features”.
5. Press the Select button. “Timeout” is displayed.
6. Press the Select button. “Timeout Duration” is displayed.
7. Press the Select button. The “Minutes” column will highlight.
8. Press the Left arrow button to scroll to the hours setting. Time out can be set from 1 minute to 10
hours.
9. Press the Enter button to save the setting. Note: To cancel any changes, press the Escape button to
exit without saving.
10. Press the Escape button to exit.
To Next Page
Loading...
Need help?
General