INTELLIPH
®
ACID DISPENSER Installation and User’s Guide INTELLIPH
®
ACID DISPENSER Installation and User’s Guide
7
Operation with IntelliTouch
®
and EasyTouch
®
Control System
When the IntellipH Controller is connected to an IntelliTouch
®
, EasyTouch
®
Control
System, the IntellipH Controller monitors the communication link between the IntelliChlor
®
SCG and the Control System.
When the IntelliChlor SCG is connected to a Control System, the cell sanitizer output
will be adjusted through the automation panel menu and NOT from the IntelliChlor SCG
control panel. The “MORE and LESS” buttons on IntelliChlor SCG are disabled.
If the Control System sends out a 0% output command to the IntelliChlor SCG, the cell
output percentage display will be blank which indicates no chlorine is being produced.
The IntellipH dispenser will display SYSTEM OFF, WILL NOT DISPENSE. No acid will be
dispensed during this time.
If the automation panel is in SPA MODE or the IntelliChlor SCG output is set to 1% -5%,
the IntellipH Acid Dispenser will display SPA MODE, WILL NOT DISPENSE. Acid will not
be dispensed while this is displayed. This is a safety feature.
Setting up the system for the first time
For best operation, the IntellipH
®
Acid Dispenser system should be configured to match
your basic acid needs. Perform the following steps to setup the system:
• Use a Test Kit to balance the pool water
• Measure the water pH
• Operate the IntellipH Acid Dispenser system for one week
• Monitor the pH regularly and adjust the acid dispensing amount using the
“More” or “Less” buttons as required.
IntellipH
®
Acid Dispenser Installation
To Next Page
Loading...
Need help?
General
