INTELLIPH
®
ACID DISPENSER Installation and User’s Guide
Dispense Amount
Pressing either the MORE or LESS button,
will display the following:
This setting controls the acid dose size every hour, and it has a range of 0-100%. The
initial factory setting is at 50%. Increasing this percentage will increase the acid dispense
amount that occurs every 60 minutes. Decreasing this percentage will decrease the acid
dispense amount. Check the pool pH level weekly and adjust this value accordingly to
maintain your pool at a pH between 7.2 to 7.4. Dispense amount can also be accessed
through the menu system.
Press the MORE button to raise this percentage, or press the LESS button to lower this
percentage. Press the MENU key to exit this mode. The new settings will be saved in
memory.
If the water pH is low, press the LESS button to decrease the acid dispensed every hour.
Likewise, if the water pH is high, press the MORE button to increase the acid dispensed
every hour.
IntellipH
®
Controller is designed to maintain pH levels. If the pH is too high, utilize the
manual acid dispense to stabilize your pool and then operate for at least one week under
the new settings and re-check the pool water pH level.
It may take several weeks of adjusting the dispense percentage before a final setting is
attained for your pool. Bather load, organic loads, filter pump time, and amount of chlorine
produced all affect the pH level.
DISPENSE AMOUNT
50%
_ _ _
Note: 128 Oz. = 1 Gallon
4
To Next Page
Loading...
Need help?
General
